The unreasonable structure of the original structure or the change of structure according to one's own ideas is a situation that many decorators may encounter when designing a house. Wall removal is the most common method. The houses are diverse in structure and complex in structure. Once inadvertent, there will be a lot of trouble.
Complex structure, need to distinguish professional
The wrong approach: The old house was overhauled and the structure was not known. The work was started only on the basis of experience, resulting in the demolition part being exactly the bearing wall. After being known by the property, not only the fine but also the part of the wall that was knocked out was added.
The correct approach: The structure of the old house is complex and it is difficult to distinguish the nature of the wall. Finding ordinary decoration workers is prone to misidentification. It is best to find professionals or veterans to determine.
Drawings are important and need to be confirmed repeatedly
The wrong approach: drawings have errors, construction workers did not pay attention, knocked down the cement wrapped outside the reinforced concrete columns. They did not know that this was a load-bearing wall structure until the steel bar was stopped.
Correct practice: Drawings are the basis for construction. A point or a horizontal line will affect the construction. Therefore, before the drawing is issued, it must be repeated.
Infrastructure, don't change at will
The wrong approach: In order to make the house look a bit higher, the owner hopes to cut as much as possible the lower edge of the lintel. The rebar can be exposed outside the wall.
The correct approach: When designing a house, you cannot consider only the needs of each person and the beauty of the house, and ignore the original structure. Only under the conditions allowed by the original structure can it be properly reconstructed.
The wall is empty and real, discerning caution
Wrong approach: The brick wall can be knocked out, but it is also necessary to determine if there is a pipe through the wall. This construction worker stops his hand until he sees the pipe, and if he knocks on the pipe, it can be a big trouble.
The right approach: Do not assume that the walls are all solid, and some will have pipelines. Before dismantling, it is necessary not only to identify whether the wall is load-bearing, but also to determine whether there are pipes or other things passing through the wall.
Careful construction and avoid rework
Wrong way: During the construction, the construction staff did not dismantle according to the drawing size, and knocking should not be performed.
Wrong way: During construction, the construction staff knocked the two door openings to the wrong height.
Correct practice: The construction personnel can draw lines on the wall according to the drawings before construction. If they are struck on the basis of the line, they will not cause the above two cases to make mistakes and avoid duplication of work.
Ordinary fitters do not have professional knowledge and do not understand whether or not the wall is weighted. The partition between the general room and the room is load-bearing. The partition wall of the bathroom is not load-bearing. It doesn't matter if you punch holes in the load-bearing walls or open doors. The best advice is to ask professionals to come and confirm what is more reliable. Special attention should be paid to the refurbishment of second-hand houses and old houses. Since such houses may not have complete drawings, they should pay more attention before dismantling.
Notices Entrance Decoration Restaurant Decoration Home Decoration Design Room House Design Cement Toilet Design Bathroom Door Size Bathroom Size Bathroom Door
Candy Thermometer,Instant Read Milk Thermometer,Glass Candy Cooking Thermometer,Wireless Kitchen Thermometer
Xi'an Lonn M&E Equipment Co., Ltd. , https://www.smartmeasurer.com