As one of many smart products, smart toilets are no exception. Compared with the ordinary toilet, the smart toilet gives us a more comfortable and convenient feeling, but after a long time of use, the smart toilet will inevitably have some fault problems, not only the fault of the ordinary toilet, but also some problems of intelligence.
The toilet is one of the household products with high frequency of use at home. If it is out of order, it is quite inconvenient to use. Today, we will learn about the common faults and maintenance methods of smart toilets.
Problems with smart toilets
Blockage: insufficient flushing or falling into foreign objects or aging will cause the toilet to clog. If it is a soft object, use a simple dredge tool can generally be solved. If it is a hard object, it is generally necessary to open the toilet.
Leakage: The aging or damage of the toilet tank fittings is generally unsatisfactory. Generally, there is a problem with the float or the water seal. Replace it.
Installation problem: Use glass glue or cement when installing at the bottom. Do not seal the screw holes on the bottom of the toilet when installing.
Button failure: The most common is the double button. If the button fails, it can be replaced directly.
How to deal with problems with smart toilets
The water is not hot (others are normal): check the remote control, the water tank heating tube, the water temperature sensor, the thermal fuse and the computer board.
Treatment: Whether the remote control temperature setting is normal temperature? Wait for 10 minutes. If there is no heat, please unplug the measuring tank. The resistance of the heating line is about 92 ohms. Then measure whether there are 92 ohm resistors at both ends of the heating tube. If the fuse is not broken, the resistance value (25K ~ 80K) at both ends of the temperature sensor is normal. If it is normal, the computer board is broken. For example, if the water tank is changed, the detection is normal after the replacement. If the water is heated, the computer board will be replaced.
The seat temperature is not heated (other normal): check the remote control, the seat heating wire, the temperature sensor, the computer board and the connector.
Treatment method: set the heating state with the remote control (waiting for 10 minutes) If there is no heating, please unplug the heating wire of the seat to measure the resistance at both ends of 960 +/- 50 ohms. If there is no electric heating wire open, if there is temperature measurement The resistance at both ends of the sensor (5K ~ 15K) is normal, is the connector in good contact? If it is normal, the computer board is broken. If the seat is changed, the detection is normal after the change. If the seat is always heated, the computer board must be replaced.
The air temperature is not hot (others are normal): Check the drying unit and the computer board.
Treatment method: Measure whether there is 89+/-4 ohm resistance at both ends of the drying electric heating wire frame. If not, the drying device is broken. If yes, confirm the correct seating and press the drying key to measure whether there is 220V voltage at both ends of the heating wire frame socket. If there is no voltage, the computer board is broken. If the drying device is changed, the computer board should be carefully checked. Remark: If the short circuit between the motor slots is sometimes caused by the increase of the load and the slowdown of the speed, the heating wire frame will open, which will cause the computer board D882 to burn out. At that time, please refer to the computer board and the drying device at the same time.
The unique design of the smart toilet is very popular among many families, but no matter which item is used, there will always be problems after using it for a long time. Xiaobian will share these problems and hope to help you.
Stainless Steel Hinges,Steel Hinges,Stainless Steel Door Hinges,Stainless Hinges
Ningbo Hengchieh Locking Technology Co., Ltd. , https://www.hengchieh.com