How to reduce toilet splash

"The toilet does not splash," and many people consider this issue when choosing a toilet. No one wants to be splashed with water when it is convenient. It is an unpleasant matter both from a sanitary point of view and psychologically. So there is no toilet to avoid the "splash event"?

The expert’s reply to this question is: “Stick without sticking”. If there is no water in the toilet, splashing will not occur, but it will cause the dirt to stick to the surface of the toilet and cannot be stinked. As long as there is water in the toilet, it will inevitably splash. However, a well-designed toilet can reduce the possibility of splashing.

Causes of toilet splashes are manifold, such as the structure of the toilet, the height of the toilet, the angle of water entering, and the physical condition of the user. One of the most important factors influencing the splashing water is the height of the toilet. The higher the height of the toilet, the greater the speed at which it enters the water, and the greater the momentum when entering the water. According to the results of the researchers' experiments, when the height of the feces is greater than 200 mm, splashing is serious, and when the height of the feces is less than 140 mm, water is rarely splashed, and the critical height is 160 mm.

The height of the toilet seat is determined by the difference between the height of the toilet seat and the height of the water seal. Today, the toilet seat height is based on ergonomic design, and the general height is similar to that of a normal person. Therefore, the level of water seal is directly related to the problem of splashing water, and it is also a barrier to the odor effect of the toilet. Install the seat into the use state, then slowly fill it with water until water flows out from the waste outlet. Measure the distance between the bottom of the toilet water and the water surface with a steel tape measure to the water seal of the toilet. The national standard for toilet water seals is 50mm, and the generally better product water seals are between 55 and 60mm. So if you want to pick a toilet that is not easy to splash, it is best to choose a product with a water seal height of 55-60mm.

Keywords: Home decoration construction supervision

Villa design entrance decoration toilet home decoration decoration design

PMV Series

Pmv Series,Grease Pump System,Ubrication System For Agricultural Machinery,Steering Lubrication Pump

Yantai Ciso Lubrication Technology Co.,LTD , https://www.cisolubrication.com