In the home decoration, a lot of wires and cables will be used. In addition to the necessary power supply wires, there are many weak wires such as telephone lines, network cables, and TV signal cables, which need to be installed, so that there is no randomness in the whole home. The effect of the line is beautiful. Generally, the weak wires in the home are installed in the dark, and how to install the weak wires in the home? Take a look at how to say it!
1. Determine the location of the weak wire indoor access point:
In this part, the owner needs to tell the designer about his own habits and functional requirements. For example, if you install a TV in the bedroom, you need to install the TV signal cable interface on the wall of the bedroom. In the study room, you need to use the computer in the study. The network cable interface is installed on the wall; when installing a telephone in the bathroom, the access point of the telephone line needs to be led to the wall of the bathroom.
2, the line:
The bullet line uses an ink-impregnated line that is bounced on the ground or on the wall. The function is to determine the position of the weak wire from the weak box to the access point, providing a reference for the later buried line.
3, shaving tank:
According to the path of the wire, the wire trough for the buried pipe is manually cut on the wall. It should be noted that the steel bar must not be damaged when shaving.
4. Pre-buried pipeline:
In the process of dark embedding, it is strictly forbidden to bury the bare wires directly in the wall, so a conduit is required.
5, start to thread:
Pull the TV signal line, telephone line, network cable, etc. to be buried from the weak box to the line pipe, and pass through the line pipe until the interface on the final wall.
6. Whether the acceptance line is smooth:
After the threading is completed, it is necessary to check and accept the wires worn by a multimeter and other equipment to check whether the line is unobstructed, whether there is a breakpoint or a short circuit.
7, repair the wall:
After the overall renovation project is completed, install the corresponding panel at the weak wire interface on the wall. Cover the project. After the pipe is buried and threaded, the shaving groove needs to be covered. For example, for the wall shaving, the gutter should be closed with caulking gypsum, then the caulking tape should be used for the post, and then the wall decoration will be carried out for the ground shaving. Apply cement mortar to fill the tank and level it, then lay the floor or floor tiles normally.
The above is the main installation method and steps of the weak wire in the home. Although the steps are very simple, it is also necessary to pay attention to the quality of the details during the installation process. Otherwise, although the function of the weak wire in the home is achieved, the wall or the ground is not flat or repaired. Going to the original position will greatly affect the beauty of the entire home!
Concerned about surprises
Label: How do home weak wires be buried?
Previous: What are the main problems with fingerprint locks? Next: How to choose aluminum alloy doors and windows?
Stearyl Erucamide,Octadecyl Erucamide Cas 10094-45-8,Cas 10094-45-8,Octadecyl Erucamide
Jiangxi Zhilian Plastics & Chemicals Technology Co., Ltd , https://www.zhilian163.com