Hanyi Transformer Winding Deformation Tester is composed of measuring part and analysis software part. The measuring part is controlled by high-speed MCU and consists of signal generation and signal measurement. The analysis part is completed by laptop computer. The measurement part is connected by USB universal interface and laptop computer. Plug and play, easy to use.
Hanyi transformer winding deformation tester features:
1. USB communication interface between PC and instrument.
2. The hardware movement adopts DDS special digital high-speed sweeping technology (USA). Through testing, it can accurately diagnose the winding distortion, bulging, shifting, tilting, inter-turn short circuit deformation and phase contact short-circuit.
3. High-resolution dB value measurement, dual-channel 16-bit A/D (changed tap changer in field test, that is, there is obvious output change).
4. The signal output amplitude can be adjusted by software with a peak amplitude of ±10V.
5. The computer will generate test results electronic document (WORD)
6. The finished circuit board has special treatment on the surface and it has anti-water and harmful gas pollution.
7. Notebook computers and measuring instruments are powered by isolated power supplies to eliminate outside interference.
Hanyi transformer winding deformation tester features:
1. USB communication interface between PC and instrument.
2. The hardware movement adopts DDS special digital high-speed sweeping technology (USA). Through testing, it can accurately diagnose the winding distortion, bulging, shifting, tilting, inter-turn short circuit deformation and phase contact short-circuit.
3. High-resolution dB value measurement, dual-channel 16-bit A/D (changed tap changer in field test, that is, there is obvious output change).
4. The signal output amplitude can be adjusted by software with a peak amplitude of ±10V.
5. The computer will generate test results electronic document (WORD)
6. The finished circuit board has special treatment on the surface and it has anti-water and harmful gas pollution.
7. Notebook computers and measuring instruments are powered by isolated power supplies to eliminate outside interference.
Non-tapping screws are machine Screw, the pieceworker to be fastened must be tapped with taps in the screw hole in advance to match the screw threads.
The difference between tooth screws and other screws depends on whether they can be used together with nuts. Tooth screws can be used with nuts. And relative to the screws of other teeth, there are self-tapping screws. The nut of this kind of screw has no bow teeth. As for the standard teeth and fine teeth are only different pitch, it is the nut of the machine screw
Hex Machine screw,pan machine screw,flat machine screw,truss machine screw,Hexagon socket screws
Shenzhen Lanejoy Technology Co.,LTD , https://www.szlanejoy.com