In order to make the room more beautiful and complete, almost all the owners will lay solid wood flooring for the living room. Because it has the characteristics of cool in winter, cool in summer, and good in touch, it makes it an ideal decoration material for bedrooms and study floors. However, laying is not an easy task. The following will bring you solid wood flooring installation skills . I hope it will be useful.
Solid wood floor installation skills 1, pavement, the plate should be matching and trial shop, and the direction of the pavement, the puzzle pattern should meet the design requirements. Then, the floor nails and mouthpieces should be fixed. When they are fixed, they should be screwed in at an angle of 30°-45° from the tongue and groove.
Solid wood floor installation techniques 2, paving solid wood floor fixed point should meet the design requirements, and paving to be left seams, solid wood floor surface layer reserved gaps and sub-slot settings should meet the design requirements, joints should be staggered, Can check the film. Then, when paving a solid wood floor of fixed length or indefinite length, the adjacent plates in the longitudinal direction should be tightly aligned with each Other, and the width of the reserved joints in the transversely adjacent plates should meet the design requirements.
Solid wood floor installation techniques 3, solid wood flooring prime panel should be planed grinding, along the direction of wood grain grinding, cutting total amount should be controlled at 0.3-0.8mm. Followed by the skirting board, solid wood skirting board should be opened on the back of the wall ventilation slots and for corrosion protection, ventilation groove depth should not be less than 5mm, the width should not be less than 30mm; should use nails nailed in the wood block, nail cap should be flattened Into the board surface, no obvious nails, skirting board should be vertical, the mouth is horizontal. Moreover, the height of the skirting board is uniform and highly uniform; the surface thereof should be smooth and the joints tight.
Solid wood flooring installation skills 4, then the wooden skirting board Yin, Yang angle, should be assembled after cutting angle. Pavement must not only meet the standards, inspection is also essential. The wooden keel and the artificial board cushion layer should be installed firmly and flatly. The spacing and stability of the wooden keel and the artificial board cushion must also meet the design standards and requirements for the moisture-proof insulation layer and the waterproof node.
Solid wood floor installation techniques 5, In addition, the deviation of solid wood floor surface pavement shall not exceed the specified value. The surface layer should be laid firmly and without any looseness; at the same time, the amount of formaldehyde released and all types of treatment agents must also meet the requirements for harmful substances as stipulated by the relevant national standards. Here we must remind everyone that it must be very careful and serious when laying out, so as not to affect the appearance in the future, or even the possibility of rework, it would be troublesome.
Xiao Bian concludes: The above is all the introduction of solid wood floor installation techniques , as long as you master the content of the above, Xiao Bian believe that laying solid wood flooring is not difficult for you. In fact, different floors and different use areas will have different methods of laying. Therefore, we must do more to understand.
J Type Foundation Bolt,Foundation Bolt J Type,J Type Anchor Bolts Specifications ,J Hook Anchor Bolt
Kunshan Zhonggu Precision Hardware Co., Ltd. , https://www.zgfastener.com