Slewing bearing device operating instructions

Source: China Bearing Network Time: 2013-07-08

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

1. Before the slewing bearing device of the slewing bearing; first check the device surface of the main machine; the required supporting member should have the required strength; the connecting surface should be machined; the outer surface is smooth without debris and burrs. The flatness required; the special plastic with high writing strength can be used as the filler; to ensure the accuracy of the plane of the device and to reduce vibration.
The ferrule bearing ferrule has a quenching soft belt zone; this has the symbol "S" on the end face of the ferrule; the device should be placed in a non-load zone or a very normal load zone (the plug hole is always soft) With).
When installing the slewing bearing; it should be positioned in the radial direction; insert the tightening device bolt; and check the reverse condition of the bearing. The tightening force should be satisfied when tightening the bolt; the pre-tightening force should be 70% of the bolt data yield limit. Bolts shall be fitted with tempered flat washers and the use of spring washers shall be prohibited.
2, the slewing bearing protection device and the slewing bearing put into operation after 100 hours of continuous operation; should all check the pre-tightening torque of the device bolt can meet the demand; in the future, repeat the above-mentioned inspection once every 500 hours.
The slewing bearing device should be filled with excess grease at the end; and the bearing should be reversed while filling to make the grease evenly distributed. After the slewing bearing is in operation for a period of time; inevitably, a part of the grease will be lost; The bearing should make up one grease after 50~100 hours per distance.
3 slewing bearing transport and storage bearings in the process of transport; should be placed horizontally on the vehicle; should have ways to avoid slipping and avoid oscillation; if necessary, add auxiliary support.
The bearings should be placed horizontally in a dry, ventilated and leveled place; they should be separated from chemicals and other corrosive materials during storage. If multiple sets of bearings are required to be stacked, each set should be placed evenly along the circumferential direction. More than one level of flat wooden blocks; and the upper base blocks are placed together.
Bearings that need to be continuously stored beyond the anti-rust period; should be removed from the head and rust-proof disposal.

Recommend to friends comments close window

Bearing related knowledge

The oscillation of the bearing and the temperature of the bearing lead to the failure of the FAG bearing. The common sense of the bearing of the rolling mill is related to the wear of the plastic sliding bearing.
Several reasons for SKF bearing failure

This article links to http://
Please indicate the bearing network http://

Previous:Spindle bearing layout classification and bearing characteristics Next: Differences between bearings with dust cover and bearings with seals

Led Linear Light

Applications: hospitals, hotels, Offices, schools, shopping malls, public buildings, etc.C

Modern simple artistic design, excellent and exquisite appearance, direct lighting, aluminum lamp body, surface painting finish, anti-corrosion, anti-oxidation. Brand led chip, PMMA diffuser, higher lighting efficiency, more uniform and softer. Finishing polishing after powder coating or spray painting. Good heat dissipation, ensure the lamp lifespan, high-reliability, could be widely used in home and public places.

Led Linear Light,Linear Led Light,Led Linear Chandelier,Led Linear Ceiling Light

OLAND PHOTOELECTRIC TECHNOLOGY CO.,LTD. , https://www.olandlights.com