Door-disabled non-contact IC card (inductive IC card) The card reader is an important part of the access control system. It is the key device for the signal input of the access control system. If the access control system is compared to a person, the access control card reader is like a person. The eyes are related to the stability of the entire access control system. If an access control system controller and an electric lock are good, if the quality of the card reader is problematic, it will also cause the door to open, which will affect the acceptance and use of the project.
Medical Industry Mass Flow Meter
Sealand is a professional manufacturer of Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter, ATEX, IECEx & CE approved.
There are 2 optical switches for operation. The SET and SELECT optical switches are used to navigate the transmitter display. To activate an optical switch, move your finger 1~2mm over the optical switch close to the glass.
Mark:
1. The display will timeout without any operation in 5 min.
2. During numbers input, the decimal point will come up automatically if the first digit is 0; if not 0, please activate SELECT until decimal point shows up.
The general operation is listed as follows.
|
On Main Interfaces |
Activate SET to alternate mass and volume values. |
|
Activate SELECT to alternate main interfaces. |
|
|
Long activate SELECT to go to Setup Interface. |
|
|
Long activate SET for total reset.
|
|
|
Back to Main Interface |
Long activate SET & SELECT at the same time.
|
|
Select Submenu, Parameters & Numbers |
Activate SELECT to select the submenu, parameters or numbers. |
|
Activate SET to go to submenu or save parameters/numbers. |
|
|
Save setup |
Long activate SET to save the modified setup. |
|
Back or Exit |
Long activate SELECT. |
Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter
Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com