Oil temperature machine common fault analysis and elimination

Orland oil temperature machine, mold temperature machine is now more and more widely used, there are often some faults in the process of use, some faults are very simple, some small problems, you can solve it yourself, do not need to wait for oil temperature machine manufacturers Maintenance personnel can solve it, and some faults that can be found on the spot can also be fed back to the manufacturer, so that the maintenance personnel of the manufacturer can bring the accessories to the repair according to the analyzed faults, and the reaction is faster. Here are some common faults in the oil temperature machine:

The failure analysis and troubleshooting methods of the oil temperature machine are as follows:

1, the power indicator does not light after power on

Possible causes: warranty burnout, main power failure, transformer damage, circuit board damage, other line failure

Remedy: Replace the insurance, check the main power supply, replace the transformer, worse the circuit board, check other circuits

2, after power-on, the machine reverse indicator light is on, the buzzer has no alarm

Possible causes: The main power phase sequence is wrong, the main power supply is out of phase, the internal wiring of the machine is wrong, and the main control board is damaged.

Remedy: Swap any two lines of the main power supply, check the main power supply voltage, check the internal wiring, and replace the main control board.

3. After the pump is turned on, the low liquid level indicator lights up and the pump does not start.

Possible reasons: The fuel tank heat is insufficient after kerosene, the water supply pressure is insufficient (2KGF/CM2), and the low pressure value is set too high.

Remedy: If you want to add hot kerosene to the fuel tank until the alarm stops, increase the water pressure until the alarm stops. Reset the low pressure switch until the alarm

4, oil temperature machine overload alarm

Possible cause: The overload current protector is not adjusted enough, and the air switch burns out the phase.

Remedy: Check the current. If the current is normal, increase the current control of the overload current protector. If the current is not normal, check the air switch for phase loss. If so, replace the air switch.

Concerned about surprises

Label: Oil temperature machine common fault analysis and elimination

Previous: Daily maintenance and maintenance of electric drums Next: Reasons and solutions for high temperature tanks without cooling

ISO Standard Mass Flow Meter

Zhejiang Sealand Technology Co., Ltd. is a trustworthy manufacturer of Mass Flow Meter Coriolis, Flow Meter Coriolis, Mass Flowmeter Coriolis, Mass Meter Coriolis, Meter Coriolis, Flowmeter Coriolis, ISO/ IEC 17025 standard.

Sealand meter is certified by Zhejiang Institute of Metrology. To get such certificate, Sealand has to send all models to Zhejiang Institute of Metrology and all models are tested in their calibration lab. The lab is an ISO/IEC 17025:2005 standard lab approved by CNAS (China National Accreditation Service for Conformity Assessment). CNAS is a member of ILAC (International Laboratory Accreditation Cooperation).

Besides, Sealand has its own calibration lab, equipped with METTLER TOLEDO scales with accuracy 0.014% and the device extended uncertainty is 0.05%. The lab is also approved by Zhejiang Institute of Metrology. This certificate will stay valid only for one year, Zhejiang Institute of Metrology will send their professor to Sealand every year to check and make sure that the lab is qualified still and then issue new certificate. During the production, each meter will be calibrated in this lab for 3 times, each time at 5 different flow rate.

Mass Flow Meter Coriolis, Flow Meter Coriolis, Mass Flowmeter Coriolis, Mass Meter Coriolis, Meter Coriolis, Flowmeter Coriolis

Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com