Identification paint and spray paint

First, the process:

A, paint: three times on the substrate to play primer, paint four times, each time the paint, are sent to clean room temperature barn, baking.

B. Spray paint: Grind woolen cloth on the substrate, spray paint on it, and air dry naturally.

Second, the film.
Practice: touch the edges and corners of the paint door, whether smooth, credential; observe the color of the corners, whether the same color with the door.
Contrast: A, paint: smooth edges and corners, the same color. Prove film uniform, full color.
B, spray paint: rough edges and corners, the color is lighter than the door. Prove that the film is not uniform and the color is not full:

Third, lines.
Practice: Control the light and see if there is orange peel on the surface of the paint door.
Contrast: A. Baking paint: The surface of the door is smooth, with no grain and orange peel.
B. Spray paint: There are lines on the surface of the door, not smooth, orange peel phenomenon.
Fourth, the surface.
Practice: Touch the surface of the door to paint, if there are dust particles, bubbles.
Contrast: A, paint: The door surface is smooth and smooth. $_Gwo2
B, spray paint: Particles on the door surface, not smooth, touch a sense of strangeness.

Fifth, wear.
Practice: Hit with a hard object.
Contrast: A, baking paint: No abnormalities, no damage to the paint film.
B, spray paint: cracks, severe paint film off, off the white skin.


Baking room structure and working principle


Paint room structure

The entire paint room is an assembled structure. The room body adopts the inserting and inserting heat-insulation sprayed wallboard, which has good sealing and heat preservation performance. The side of the room body is equipped with working doors to facilitate the entry and exit of the staff; the aluminum alloy edging door has a observation window at the center of the door and can be observed at any time in the room. dynamic. Low-noise, high-air volume fans are used to ensure the perfection of the painting effect; high-quality stainless steel heat exchangers have high heat exchange efficiency and long service life.

Paint room working principle

The paint room is generally used for spraying and baking paint. Therefore, the most accurate description of the paint room should be "spray paint room."

When painting, the outside air passes through the primary filter and is sent to the roof by the fan, and then passes through the top filter and is filtered and purified into the room. The air in the room is fully descending and flows downward at a speed of 0.2-0.3 m/s, so that paint mist particles after painting can not stay in the air but are directly discharged out of the room through the bottom air outlet. This continuous cycle of conversion, so that when the painting room air cleanliness of more than 98%, and the air into the air has a certain pressure, can form a constant airflow around the car to remove excess paint, so as to ensure maximum The quality of spray paint.

When the paint is applied, the damper is adjusted to the paint position, the hot air is circulated, and the temperature in the baking room rapidly rises to a predetermined drying temperature (55°C-60°C). After the fresh air is initially filtered by the fan, the heat is exchanged with the heat exchanger and sent to the air chamber at the top of the paint booth. After a second filtration purification, the hot air passes through the internal circulation of the damper, except for a small amount of fresh air. The vast majority of hot air is again heated and utilized, causing the temperature in the paint room to gradually increase. When the temperature reaches the set temperature, the burner automatically stops; when the temperature drops to the set temperature, the fan and burner are automatically turned on again, so that the temperature inside the paint room is kept relatively constant. Finally, when the paint time reaches the set time, the paint booth automatically shuts down and the paint finishes.

Three trees paint paint paint stainless steel window aluminum alloy