Cabinet design is the first step in cabinet production and it is a crucial step that directly affects the final results and use. Now most of the plants that help you design the drawings are made of AOTUCAD planes and elevations, some are three-dimensional wireframes, we often see what seems to understand, there is no intuitive concept, etc., only to find the shortcomings after completion.
So, how can we look at the essence through drawings and buy cabinets that are really suitable for ourselves?
1. The number of meters is not high enough cabinet Minato: In order to increase the total cost of each single, designers will ignore the actual space of your home kitchen, the high cabinet design, after all, the price of high cabinet is 1.5-2 times that of ordinary cabinet, so total The price also came up. For example, the total length of your home cabinet can only be 3-4 meters. The area of ​​the kitchen is certainly not big. It is around 4-5 square meters, and the width of the high cabinet is often more than 600MM. To remove the high cabinets, sinks, stoves, the remaining countertops will be less than 1 meter. First, it is not enough in practical use; the second is the golden section method in which the ratio of cabinets and spaces exceeds 0.618 to 1.
2. Avoid bale-removing and hanging cabinets: Each house will have falling water pipes, trachea pipes, flue pipes, etc. The designer will open the packing columns in the design. This will reduce the difficulty of production and the installation of the site will be much easier. - Provincial workers. However, some small wrapping columns (within 200mm*200mm) should be packed in cabinets. The overall effect is better because there will be no pockets, and it will be difficult to clean the fumes in the future.
3. A large number of aluminum frame doors and upturned doors are used on wall cabinets. The reason is that the profits of the aluminum frame door are large, and the up-and-down door needs to be equipped with a pressure bar. It should be noted that although a small amount of profit is surprising, some of the pressure bars are over 300%. The use of aluminum frame doors and upturned doors should be adequate, generally not exceeding one-third of the total number of hanging cabinets. Such doors are of poor practicality.
4. The direction of the ornamentation is not indicated on the design drawings: Since the CAD drawing cannot represent the texture of the double panel, we generally do not consider this issue. If you use a textured door panel, note that a small area kitchen uses horizontal orientation in its use, which can be used to expand the visual effect of the space. However, such a door panel has to increase the cost by more than 20% compared with the vertical shutter panel.
5. Large kitchen design small door: more than 6 square meters of kitchen, the total length of the floor cabinet can be more than 6 meters, but some plans, the width of each door is in the 400MM up and down, the finished cabinet seemed stingy. Such cabinets, door width should be 450MM-500MM (can insert a small number of narrow doors, such as rice boxes, seasoning basket door), the size of the drawer should be greater than 700MM, can be 900MM-1 meters. However, the cost of cutting such doors is large, and the cost is more than 20% higher than that of standard doors.
Cabinets Space Doors Price Drawer Cabinets Cabinets Doors Cabinets Cabinets Doors Cabinets Doors Kitchen Doors
Square Nuts And Bolts,Square Nut Bolt,Square Thread Nut,Square Lock Nut
NINGBO YWC IMP. & EXP. CO.,LTD , https://www.nbywc-fastener.com