Nowadays, the popularity of toilets is getting wider and wider. Nowadays, the toilets are generally delivered to the door for installation, but the omission in the installation process will directly affect our daily life. Construction workers can't wait to beside them, and the power to increase supervision is the right way. Here Xiaobian brings you detailed steps in the installation of the toilet, teach you to be a qualified monitor, if you need to do it yourself.
step one
In fact, Xiao Bian tells the truth, the installation of the toilet is actually very simple, it is not very difficult. Before installing the toilet, be sure to check it thoroughly to see if the drain pipe is unobstructed. Check if the toilet is installed horizontally. If it is not horizontal, then level it when installing the toilet. In addition, the toilet pipe outlet will generally leave a large section, and the excess pipe will be sawed short, leaving about 3mm above the ground. Also, check that the size of the toilet you bought matches the space reserved in your home. After these checks are completed, the toilet can be installed.
Step two
Once it is determined, make a mark on the sewage pipe and the sewer drain pipe of the toilet bowl to determine the installation position of the toilet, use a drill to make a hole, and bury the expansion screw inside. Then install a ring of sealing ring on the sewage outlet of the toilet, and install glue or cement slurry on the sewage pipe to ensure that the sewage will not penetrate. These method steps are to test your understanding of the toilet, as well as the awareness of the toilet part. Only you understand, it will be convenient for you to install the toilet. After doing these steps, don't worry, take your time.
Step three
The third step of the toilet installation method is to align the toilet drain pipe marked by you with the sewer drain pipe. Install the toilet seat on the toilet, install a ring seal or glass glue on the bottom of the toilet to ensure the pipe of the toilet. It is consistent with the nozzle of the sewer and is stable. After the super-important two-step installation is complete, the following follow-up work is simple. Do you think that the introduction of Xiaobian is very simple, as long as you understand the internal structure of the toilet, these are just small knowledge.
Step four
The fourth step in the toilet installation method is to install the parts or accessories of the toilet. Screw on the installation place of the toilet, install the fittings of the water tank, and connect the water pipes in the bathroom. Before that, be sure to check if the water valve switch in your home is normal, check whether the toilet water pipe connected to the water valve is normal, the length is not long enough, etc., when installing the water pipe, it must be tight and non-permeable. Leakage to prevent water leakage when pumping. Although it is only a few small details, the details determine the quality of the installation.
Step five
The last step is also the easiest and easiest step. The installation of the toilet is basically completed at this time. The rest of the time is to debug the toilet to see if the drainage pipe is unobstructed, whether it is blocked or not, and whether it can be pumped normally. In addition, if there are still some problems during the debugging process, You can refer to the instructions for repairs. The general toilet installation instructions can explain in detail every possible problem and solution when the toilet is installed. Although Xiaobian is not a panacea, there is no problem in solving basic life trivia.
Flood Light,Flood Lights Outdoor,Led Floodlight,Split Flood Light
Land of Lights Electric Appliance Co., LTD , https://www.loloutdoorlight.com