In our wireless video surveillance, after the wireless bridge is installed, the next step is to enter the page to connect the front-end AP for communication. Only the front-end AP can communicate normally, and normal signal transmission can be performed. However, if the CPE cannot connect to the peer AP (the status display is not connected), what should we do? The following Xiaobian brings you to briefly explain:
1. Try to use Scan Wireless Network again to connect;
2. Confirm that the CPE wireless mode (11b/g/n) is set correctly;
3. Whether the encryption mode and key between the CPE and AP match.
4. The wireless signal strength of the peer AP is too weak. It is recommended that the wireless signal strength be greater than -75 dBm.
1. Try to use Scan Wireless Network again to connect;
2. Confirm that the CPE wireless mode (11b/g/n) is set correctly;
3. Whether the encryption mode and key between the CPE and AP match.
4. The wireless signal strength of the peer AP is too weak. It is recommended that the wireless signal strength be greater than -75 dBm.
Brass Cnc Machined Components,Brass Cnc Machining Parts,Cnc Machining Parts,High Precision Machining Components
Stand Dragon Industrial Co., Ltd. , https://www.standdragontw.com