First, the use of washing water properties:
1. LW-303 [washing water] is a high-quality mold special cleaning agent. Any serious mold dirt is completely removed in an instant, easy to use, never damage the mold, and can extend the service life of the mold.
Second, the advantages:
1. The high-temperature mold is directly cleaned, and the dirt is completely removed in an instant, without stopping the machine, and the production is not affected. After the descaling mold is clean and bright, it can improve the product quality and increase the suburban rate.
2. This product is a highly concentrated water-soluble liquid. It can be diluted with appropriate water according to the degree of pollution of the mold. It is very economical and practical, and can directly reduce the production cost. Oil stains or mild rust can also be removed.
Third, the use of:
1. Dispersion method: Please use a small amount of stock solution or diluent to spread or smear on the mold at high temperature. After 2-10 minutes, the dirt will soften and dissolve. Immediately rinse with water before the mold water is dry. The mold temperature is above 95 °C.
2. Impregnation method: the original solution or diluent is contained in the iron trough, and the heating is about 95 ° C and soaked for about 2-3 minutes. Or directly into the solution at room temperature with a high temperature mold, soak it for 2-3 minutes, then rinse it off with water.
Fourth, note:
1. This product is an alkaline solution. Wear rubber gloves when working.
2. If the hands or skin are in contact with the solution, please wash them with water.
3. Because it is an alkaline substance, aluminum molds cannot be used.
Fifth, packaging:
1. The packaging of LW-303 washing water is 20 kg, 200 kg iron drum
Diamond Segment,Diamond Blade Segment,Diamond Saw Segment
Diamond Segment,Diamond Saw Blade,Diamond Wire Saw Co., Ltd. , http://www.nsblades.com