Do not start and stop the air conditioner frequently because the room temperature has reached or exceeded the required value. Instead, the air conditioner should be controlled to start and stop through the temperature controller.
Switching you on and off frequently means "in the murder" of your air conditioner.
Since the general air conditioners are equipped with a time delay device (delay time of about 3min), this type of air conditioner can be turned on immediately after shutdown, but it will take 3 minutes to operate. However, for air conditioners without time delay, it is not possible to turn on the air conditioner immediately after shutting down. Be sure to wait for about 3 minutes before turning on the air conditioner again. Otherwise, the starting current may be too large, the fuse may be burned, or even the compressor motor may be burned.
Take the cooling mode as an example. After the air conditioner is turned on, the following two conditions may occur:
★ The air conditioner compressor starts and stops frequently, but the indoor temperature does not drop down;
★ The indoor temperature is already too low, and the air conditioner compressor does not stop running. This may be because the thermostat's temperature setting is incorrect (too high or too low). The temperature setting value should be properly adjusted so that the indoor temperature reaches the required value, so as to avoid the frequent start-stop of the air conditioner compressor or excessive deviation of the room temperature.
2, after the air conditioning boot, cooling (heat) adjustment of the amount of skills
After starting operation, the air conditioner's cooling (heating) amount can be adjusted by adjusting the air volume switch as needed.
The regulation of the cooling (heating) amount of the general air conditioner is achieved by changing the air volume (the inverter type air conditioner regulates the compressor rotation speed). Window type air conditioners are generally provided with a strong cold and weak cold or strong heat and weak heat knob, the knob is set to strong cold (hot) or weak cold (hot), in fact, adjust the air volume is high or low air volume. Remote controls used in split-type air conditioners are generally provided with high, medium and low wind speeds for selection. According to the indoor temperature requirements, the purpose of adjusting cooling or heating can be achieved by adjusting the air speed of the air conditioner.
3, the air conditioner switch operation method
Whether it is manual switch or remote control operation, the operation of the air conditioner is basically as follows:
★ According to air conditioning requirements and use requirements, select the air conditioner's operating mode, such as cooling, heating, dehumidification or ventilation. Just press the operating mode selection button on the air conditioner to select.
★ Set the temperature, adjust the temperature of the temperature regulator. In general cooling operation, the temperature range is set at 20-30°C. During heating operation, the temperature value is set in the range of 14 to 27°C. The set temperature value refers to the return air temperature or room temperature of the air conditioner. In order to check whether the compressor can run, the set value during cooling should be lower than the indoor temperature at that time, and the heating should be higher than the indoor temperature at that time. After the air conditioner is turned on, it can determine whether the compressor can operate normally.
★ After completing the above operation, turn on the air conditioner, and the air conditioner can operate normally according to the selected operation mode.
Air conditioning life coup
Gate Valves are called "full-flow" valves; there's a direct unobstructed path for flow right through the middle of the valve. A wedge-shaped brass gate is lowered into a machined slot to close the valve. They should either be completely open or completely closed. Water flowing through a partially open gate valve wears away the metal and causes the valve to fail over time.
Brass Gate Valve, Flanged Gate Valve, High Pressure Gate Valves, Water Gate Valves
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.cn-kingsir.com