Be sure to do waterproofing on the walls. Before wall tiles, make waterproof on the walls. In the general waterproofing process, the wall surface is to be waterproofed to a height of 30 cm. However, for a non-load-bearing lightweight wall, the entire wall should be waterproofed, and at least 60 cm in height must be achieved.
The seams between the wall and the ground and the pipe seams between the upper and lower water are the most prone to problems. We must urge the workers to handle these corners. The waterproof coating must be applied in place.
If you need to replace the original floor tiles in the bathroom, you must first use the cement mortar to level the floor, and then do the waterproof treatment to prevent the waterproof coating from infiltrating due to uneven thickness. leak. Before you do waterproofing, be sure to clean the floor.
As far as possible without destroying the original waterproof layer, a waterproof layer is applied on the general floor of newly delivered buildings. Therefore, the leakage of the original waterproof layer will not occur.
Use a 24-hour "water storage test" to check and waterproof. After the waterproof project is completed, close the door and the water outlet. Fill the toilet floor with water to a certain liquid level, and make a mark. If there is no liquid level within 24 hours As a result, there was no leakage in the roof of the house, particularly downstairs, and the waterproof was qualified.
Requires the decoration team to do a good job of cement lining for the upper and lower water pipes of the toilet. Brush up 10 to 20 cm of waterproof paint from the floor, and then re-do the ester waterproofing on the ground. Add the original waterproof layer to form a composite waterproof layer to enhance waterproofing. Sex.
Water grooves in the walls should also be waterproofed. When the pipelines and floor drains cross the floor during construction, the waterproof layer around the holes must be carefully constructed. Buried water pipes in the wall, so that a reasonable layout, the laying of water pipes will be greater than the diameter of the groove, smooth plaster groove, and then brush the groove waterproof coating.
Entrance decoration floor coating cement bathroom waterproof bathroom tile bathroom floor tile bathroom door
End emitting fibers (also called end glow, or end light) are the classic fiber optics, with bright points of light at the ends and very little light escaping along the strands themselves. They are usually thin, somewhere from 0.25 to 3mm in diameter. They are also generally stiffer than the side emitting fibers.
end glow fiber optic,End lit PMMA fiber,fiber optic light pipe
Jiangxi Daishing POF Co.,Ltd , https://www.jxopticfibrelight.com